PEEK PARTS, PEEK parts, PEEK screw, PEEK ball,PEEK fitting, OEM
PEEK parts
Peek parts can be OEM ,customized.
PEEK is a high-temperature , high-performance specialty engineering
thermoplastics . It has good mechanical
properties and resistance to chemicals,abrasion -resistant properties , hydrolysis , etc. ; its light
weight,
selflubricatingproperties , due to the very good processing properties, can be
filled with carbon fiber,
such as molybdenum disulfide to further improve the lubricity and
mechanical strength. PEEK plastic broad application space comes to
high-tech industries in aviation, machinery, electronics, chemical,
automotive , etc.,
may be required for the manufacture of high mechanical parts such
as gears, bearings ,piston rings, support
rings,seals ( letter ), valves, wear rings. High performance PEEK
material is mainly manifested in the following aspects :
1 . Temperature
PEEK has a high glass transition temperature and melting point (334
°C), which is one of the reasons that it requires heat resistance
can reliably use the application .
Its load thermal deformation temperature up to 316 °C, continuous
use temperature of 260°C.
2 Mechanical properties
PEEK is both toughness and rigidity and balance of plastics.
Particularly its excellent resistance to alternating stress fatigue
is the most outstanding of all plastics ,
can be comparable with the alloy material.
3 self-lubricating
PEEK has outstanding sliding properties in all plastic , suitable
for demanding low coefficient of friction and abrasion purposes.
Especially carbon fiber, graphite
certain percentage of each hybrid modified PEEK better
self-lubricating properties .
4 chemical resistance ( corrosion )
PEEK has excellent chemical resistance, in the usual chemicals that
can dissolve or destroy it only concentrated sulfuric acid , and
its resistance to corrosion and nickel steel similar.
5 flame retardant
PEEK polymer is very stable , 1.45mm thick sample , without any
flame retardant can achieve the highest standards .
6 peel resistance
PEEK excellent peeling resistance , it can be made of wire or
coated with a thin wire , and can be used in harsh conditions .
7 fatigue resistance
PEEK has the best resistance to fatigue in all resin.
8 radiation resistance
The ability of strong resistance to γ radiation over the best
general-purpose polystyrene resins radiation resistance . You can
still maintain γ radiation dose made up
1100Mrad good insulating ability when high performance wire .
9 hydrolysis resistance
PEEK and its composites from chemical effects of water and
high-pressure steam , products made of this material at high
temperature and pressure water can still
maintain excellent properties of continuous use
Properties
| Density | 1320kgs/m3 |
| Yong's modulus (E) | 3.6Gpa |
Tensile strength(σt) | 90-100MPa |
Elongation @ break | 50% |
Notch test | 55kJ/m2 |
Glass temperature | 143 °C |
Melting point | 343 °C |
Thermal Conductivity | 0.25 W/m.K |
Water absorption, 24 hours (ASTM D 570) | 0.1% |
Application:
1 . Gears
2. Wear strips
3. Bushes
4. Metering pumps
5. Light mountings
6. Friction bearings
7. Ball valve seals
8. Pump housings
9. Wafer supports
10. Plug parts
Specification :
PEEK film:0.4-0.5mm x 600mm PEEK sheet: thickness 1-100mm x Width
1000mm
PEEK rod: Dia 8-200mm PEEK tube: Dia1.6-320MM
